I too have a Stronglite. The metal frame one (not the wooden one), and I must say, it hasn't fallen apart yet, or even shown much wear and tear. I have noticed the wheel look a "little" worn after 7 years and there are a few scratches on the "plastic feet". There are some plastic do-dads on the other stabilization part (near the wheels), so that's what I am talking about. The cushions are in good condition and I have a few scratches on the metal frame, but not any rust.
I used it once a week for a five hour stint and haul it about 70 miles on those given days for about 2 or 3 years now, and yes, I can say it is a good chair. (Just stopped that job about 2 months ago).
I literally drop it in the back of my truck (in it's nylon bag of course) when taking it from place to place (unless there is rain, then it travels in the cab with me --- well, I think it got caught in the back of the truck in rain twice... but, well, sometimes rain shows up pretty fast). When it drops into the truck over the tailgate, I put the roller feet part in first and then roll it toward the cab and let it fall into place. I am not big on trying to ease it in, or place it here and there. I am sure people who are all careful with their belongings are shuddering right now. But it makes the banging sound when it finally falls into place. Just so you know what kind of wear and tear I am talking about.
When I take it on site, I lay it on the floor, unzip the carrier, pull it out, and with one pull, move the frame into position, turn it upright and am ready to go. Head rest always stays in position, and I travel with it, with the headrest connected - always. Nary a problem.
I have a tendency to be "hard" on my equipment. Just am. So, for me, the Stronglite fit my use pattern better from what I could see.
As for the wheels on the stronglite: I can take or leave them, only because they aren't big wheels and if you hit a bump on concrete, an asphalt drive or a sidewalk dip, they really only make it so the chair gets off balance and then you are doing funky hand tricks to keep the chair upright. If I could make a suggestion to stronglite, it would be to find a way to use wider and better wheels (maybe like the ones on the new travel bags that are coming out now-days -- you know, the thick, wide hard plastic ones on your luggage for travelling on an airplane, etc.)
Of course, if you have a really smooth surface, the wheels are wonderful. I have never used a chair without wheels for any amount of time, so maybe I am taking them for granted and I use them more than I think I do. It is hard to say.
It has removable shin rests and I have only used them twice now, but they are nice to have when you need them.
No one has ever complained of the chair "cut into the thighs" which was mentioned about
here. (
Title: Good chair, bad chair)
It does not have a center bar which was also mentioned about other chairs in the above mentioned thread. Many of the chair massages I performed were at a bank where many of the employees wear skirts, and we have never had a problem with any "flesh showing" that would be stressful for the client or unprofessional.
The stronglite does not have any "spring" to it, like the Earthlite has, so if that is a factor you may want, it is something to keep in mind.
Hope that helps.